Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK CONTROL SENSOR


    A128924E09
  1. Install the knock control sensor with the bolt so that the knock control sensor is positioned as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    Text in Illustration 
    *a
    Front of Engine
    *b
    Up
    *c
    10°
    *d
    10°

    NOTICE:
    The acceptable installation angle of the knock control sensor is between 10° upward and 10° downward from the horizontal position.

  1. Connect the knock control sensor connector.



2. INSTALL INTAKE MANIFOLD
(Click here)