Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE CONTROL › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL ECM
  1. Install the No. 1 ECM bracket and No. 2 ECM bracket to the ECM with the 4 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Install the ECM with the 2 nuts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



    A265323
  1. Connect the 2 ECM connectors and lower the 2 levers.

    NOTICE:
    1. When connecting the connectors, make sure that dirt, water or other foreign matter is not stuck between the connectors and connecting part of the ECM.
    2. Make sure that the 2 levers are securely locked.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. PERFORM INITIALIZATION
(Click here)