Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE CONTROL › ECM

ECM > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE ECM


    A264422
  1. Disconnect the 2 ECM connectors.

    1. Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

      NOTICE:
      After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.



    A289780
  1. Remove the 2 nuts and remove the ECM.



    A264439
  1. Remove the 4 screws, No. 1 ECM bracket and No. 2 ECM bracket.