Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR
  1. Clean and degrease the threads of the bolt for the crankshaft position sensor.



    A095436E08
  1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
    Text in Illustration 
    *1
    O-ring

    NOTICE:
    Make sure that the O-ring is not cracked or moved out of place during installation.



    A275560E01
  1. Install the crankshaft position sensor with the bolt.
    Text in Illustration 
    *1
    Wire Harness Clamp Bracket
    *2
    Wire Harness

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    Do not twist the O-ring.

  1. Install the wire harness clamp.

  1. Install the connector to the wire harness clamp bracket.

  1. Connect the crankshaft position sensor connector.



2. INSTALL GENERATOR ASSEMBLY
(Click here).


3. INSPECT FOR OIL LEAK