Home › Engine / Hybrid System ยท 1AZ-FE › COOLING › WATER PUMP

WATER PUMP > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FOR COOLANT LEAK

HINT:
  1. Before performing this inspection, check that there is no engine coolant leaking from any parts other than the engine water pump assembly. If there are leaks, inspect those areas.
  2. Perform this inspection when the engine is cold.

  1. Visually inspect the engine compartment for the following conditions:

    1. There is a large amount of engine coolant in the engine compartment or on the underside of the hood near the V-ribbed belt.

    2. Engine coolant is dripping from around the engine water pump assembly.

    3. The engine coolant level in the radiator reserve tank assembly is below the low line and there are traces of leakage around the engine water pump assembly.
      If any of the above conditions exist, replace the engine water pump assembly.
      If none of the above conditions exist, perform the following inspection (inspection of the area around the engine water pump assembly).

  1. Remove the V-ribbed belt (Click here).

  1. Remove the water pump pulley .



  1. Inspect the area around the engine water pump assembly.

    HINT:
    Check for deposits around the drain plug of the engine water pump assembly.




      A232904E02
    1. Press a piece of paper towel against the drain plug and check that the paper towel is not wet and that there are no deposits on the lip of the drain plug.
      Text in Illustration 
      *1
      Drain Plug
      If the paper towel is wet, replace the engine water pump assembly.
      If the paper towel is not wet, thoroughly clean the area around the engine water pump assembly.

  1. Install the water pump pulley .



2. INSPECT ENGINE WATER PUMP ASSEMBLY


    A264140
  1. Turn the pulley and check that the water pump bearing moves smoothly and quietly.
    If necessary, replace the engine water pump assembly.

  1. Install the V-ribbed belt (Click here).