Home › Drivetrain ยท U241E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION WIRE
  1. Coat a new O-ring with ATF and install it to the transmission wire.

  1. Install the transmission wire to the automatic transaxle assembly with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Coat the O-ring of the ATF temperature sensor and bolt with ATF.

  1. Install the ATF temperature sensor with the lock plate and bolt.

    Torque:
    6.6 N*m{ 67 kgf*cm , 58 in.*lbf }

  1. Connect the 5 connectors to the transmission valve body assembly.



2. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    C209099E02
  1. Install the 2 magnets in the automatic transaxle oil pan sub-assembly.
    Text in Illustration 
    *1
    Magnet

  1. Clean and degrease the bolt holes.

  1. Apply adhesive to 18 new bolts.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.

  1. Install a new gasket and the automatic transaxle oil pan sub-assembly with the 18 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }

    NOTICE:
    1. Apply adhesive to the bolts and tighten them within 10 minutes of application.
    2. Do not add ATF within 2 hours after installing the automatic transaxle oil pan sub-assembly.
    3. Do not start the engine for at least 2 hours after installing the automatic transaxle oil pan sub-assembly.



3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
(Click here)