Home › Drivetrain ยท U241E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
(Click here)


2. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    C083111E01
  1. Remove the 18 bolts, automatic transaxle oil pan sub-assembly and gasket from the automatic transaxle assembly.

    NOTICE:
    Some fluid will remain in the automatic transaxle oil pan sub-assembly.
    Remove all the automatic transaxle oil pan sub-assembly bolts, and carefully remove the automatic transaxle oil pan sub-assembly.

  1. Remove the 2 magnets from the automatic transaxle oil pan sub-assembly.



    AT00103
  1. Examine the particles in the automatic transaxle oil pan sub-assembly.

    1. Collect any steel chips using the removed magnets.
      Carefully inspect the foreign matter and particles in the automatic transaxle oil pan sub-assembly and on the magnets to see the type of wear which might be found in the automatic transaxle assembly.
      Steel (magnetic): bearing, gear and clutch plate wear
      Brass (non-magnetic): bushing wear



3. REMOVE TRANSMISSION WIRE


    D025591E09
  1. Disconnect the 5 connectors from the transmission valve body assembly.
    Text in Illustration 
    *1
    Lock Plate

  1. Remove the bolt, lock plate and ATF temperature sensor.



    C271756
  1. Remove the bolt and transmission wire from the automatic transaxle assembly.



    D003636E03
  1. Remove the O-ring from the transmission wire.