VALVE BODY ASSEMBLY > REMOVAL |
| 1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY |
| 2. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
![]() |
Remove the 18 bolts, automatic transaxle oil pan sub-assembly and gasket from the automatic transaxle assembly.
Remove the 2 magnets from the automatic transaxle oil pan sub-assembly.
![]() |
Examine the particles in the automatic transaxle oil pan sub-assembly.
Collect any steel chips using the removed magnets.
Carefully inspect the foreign matter and particles in the automatic transaxle oil pan sub-assembly and on the magnets to see the type of wear which might be found in the automatic transaxle assembly.
Steel (magnetic): bearing, gear and clutch plate wear
Brass (non-magnetic): bushing wear
| 3. REMOVE VALVE BODY OIL STRAINER ASSEMBLY |
![]() |
Remove the 3 bolts and valve body oil strainer assembly from the transmission valve body assembly.
![]() |
Remove the O-ring from the valve body oil strainer assembly.
| 4. REMOVE TRANSMISSION VALVE BODY ASSEMBLY |
![]() |
Disconnect the 5 connectors from the transmission valve body assembly.
| *1 | Lock Plate |
Remove the bolt, lock plate and ATF temperature sensor from the transmission valve body assembly.
![]() |
Support the valve body and remove the 17 bolts and transmission valve body assembly.
![]() |
Remove the check ball body and spring from the transmission valve body assembly.
| 5. REMOVE MANUAL VALVE |
![]() |
Remove the manual valve from the transmission valve body assembly.