TORQUE CONVERTER AND DRIVE PLATE > INSPECTION |
| 1. INSPECT TORQUE CONVERTER ASSEMBLY |
Inspect the one-way clutch.
![]() |
Set SST into the inner race of the one-way clutch.
Install SST so that it fits in the notch of the torque converter assembly hub and the outer race of the one-way clutch.
![]() |
Stand the torque converter assembly up and turn SST.
| *a | Hold |
| *b | Turn |
![]() | Lock |
![]() | Smooth |
![]() |
Inspect the torque converter assembly.
If any of the following problems are present, replace the torque converter assembly.
| *a | Sample showing maximum allowable amount of powder in ATF |
| *b | Full Scale |
Replace the ATF in the torque converter assembly.
![]() |
Clean and check the oil cooler and oil pipe line.
![]() |
Prevent deformation of the torque converter assembly and damage to the oil pump gear.
| *a | Correct |
| *b | Incorrect |
| *c | Bottom is damaged |
| 2. INSPECT DRIVE PLATE |
Check the drive plate for damage.
![]() |
Set up a dial indicator and measure the runout at the 6 areas on the drive plate surface that contact the torque converter assembly.
![]() | Measurement Point |