Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL REAR ENGINE OIL SEAL
  1. Apply MP grease to the lip of a new rear engine oil seal.

    NOTICE:
    Do not allow foreign matter to contact the lip of the rear engine oil seal.



    A264399E01
  1. Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the edges of the cylinder block and crankcase.

    SST
    09223-15030  
    09950-70010   (09951-07100)

    NOTICE:
    1. Keep the lip of the rear engine oil seal free from foreign matter.
    2. Do not tap in the rear engine oil seal at an angle.



2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A264398E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. Clean the bolts and their installation holes.



    A193984
  1. Install the front drive plate spacer.

    HINT:
    Align the pin of the front drive plate spacer with the pin hole of the crankshaft.



    A264403E01
  1. Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.
    Text in Illustration 
    *1
    Drive Plate And Ring Gear Sub-assembly
    *2
    Rear Drive Plate Spacer
    V100135
    Transaxle Side



    A192239E03
  1. Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.
    Text in Illustration 
    *1
    Adhesive

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



    A264396E02
  1. Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

    Torque:
    98 N*m{ 999 kgf*cm , 72 ft.*lbf }

    NOTICE:
    Do not start the engine for at least an hour after installing the drive plate and ring gear sub-assembly.



3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
(Click here)