RADIATOR > INSTALLATION |
| 1. INSTALL RADIATOR ASSEMBLY |
![]() |
Install the fan assembly to the radiator assembly with the 2 guides at the bottom and 3 claws on the top.
| *1 | Guide |
Install the 2 lower radiator supports to the radiator assembly.
![]() |
Install the radiator assembly with fan assembly.
Install the condenser assembly with the 4 bolts.
Connect the 2 connectors and the 2 clamps.
| 2. INSTALL UPPER RADIATOR SUPPORT |
Install the 2 radiator support cushions to the radiator assembly.
Install the upper radiator support with the 5 bolts and connect the hood lock control cable clamp to the upper radiator support.
Connect the 2 connectors.
| 3. INSTALL HOOD LOCK ASSEMBLY |
![]() |
Apply MP grease to the sliding areas of the lock.
Connect the hood lock control cable assembly.
Install the hood lock assembly with the 2 bolts and hood lock bolt.
Connect the connector.
| 4. CONNECT OUTLET NO. 1 OIL COOLER HOSE |
Connect the outlet No. 1 oil cooler hose.
| 5. CONNECT INLET NO. 1 OIL COOLER HOSE |
Connect the inlet No. 1 oil cooler hose.
| 6. CONNECT NO. 2 RADIATOR HOSE |
Connect the No. 2 radiator hose and clamp.
| 7. CONNECT NO. 1 RADIATOR HOSE |
Connect the No. 1 radiator hose.
| 8. INSTALL RADIATOR RESERVE TANK ASSEMBLY |
Install the radiator reserve tank assembly with the 2 bolts.
Connect the radiator reserve tank hose.
| 9. INSTALL INLET AIR CLEANER ASSEMBLY |
Install the inlet air cleaner assembly with the 2 bolts.
| 10. INSTALL FRONT BUMPER ASSEMBLY |
| 11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 12. ADD ENGINE COOLANT |
Tighten the radiator drain cock plug by hand.
Tighten the cylinder block drain cock plug.
Slowly fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
Slowly pour engine coolant into the radiator reserve tank assembly until it reaches the full line.
Squeeze the No. 1 and No. 2 radiator hoses several times by hand, and then check the level of the engine coolant.
If the engine coolant level is low, add engine coolant.
Install the radiator cap sub-assembly and reserve tank cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the engine coolant for several minutes.
Maintain the engine speed at 2000 to 2500 rpm.
Squeeze the No. 1 and No. 2 radiator hoses several times by hand to bleed air.
Stop the engine and wait until the engine coolant cools down.
Add engine coolant to the full line on the radiator reserve tank assembly.
| 13. INSPECT FOR COOLANT LEAK |
![]() |
Fill the radiator assembly with engine coolant and attach a radiator cap tester.
Warm up the engine.
Using a radiator cap tester, increase the pressure inside the radiator assembly to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator assembly and engine water pump assembly for leaks. If no external leaks are found, check the heater core, cylinder block and cylinder head.
| 14. INSTALL ENGINE UNDER COVER LH |
| 15. INSTALL ENGINE UNDER COVER RH |
| 16. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH |
| 17. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH |