FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FOR FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAKS |
Check fuel pump operation.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check for pressure in the fuel tube sub-assembly from the fuel line. Check that sounds of fuel flowing from the fuel tank assembly can be heard. If no sounds can be heard, check the integration relay, fuel pump, ECM and wiring connectors.
Inspect for fuel leaks.
Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.
Turn the ignition switch off.
Disconnect the intelligent tester from the DLC3.
| 2. CHECK FUEL PRESSURE |
Discharge the fuel system pressure (Click here).
Using a voltmeter, measure the battery voltage.
Disconnect the cable from the negative (-) battery terminal.
Disconnect the fuel pipe from the fuel tube sub-assembly (Click here).
![]() |
Install SST (EFI fuel pressure gauge) as shown in the illustration.
| *1 | SST (Hose Band) |
| *2 | SST (T-joint) |
| *3 | SST (Gauge) |
| *4 | SST (Hose Joint) |
| *5 | SST (Hose) |
| *6 | SST (Fuel Tube Connector) |
| *7 | Fuel Tube Sub-assembly |
| *8 | Fuel Pipe |
Wipe up any spilled fuel.
Connect the cable to the negative (-) battery terminal.
Connect the intelligent tester to the DLC3.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Measure the fuel pressure.
Disconnect the intelligent tester from the DLC3.
Start the engine.
Measure the fuel pressure at idle.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes after the engine stops.
After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove SST to prevent fuel from spraying.
Reconnect the fuel pipe to the fuel tube sub-assembly (fuel tube connector).
Install the No. 1 fuel pipe clamp to the fuel tube connector.
Inspect for fuel leaks (See step 1).