FUEL PUMP > INSTALLATION |
| 1. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY |
![]() |
Install a new fuel suction tube set gasket to the fuel suction tube.
| *1 | Fuel Suction Tube Set Gasket |
Install the fuel suction tube with pump and gauge assembly to the fuel tank.
| 2. INSTALL FUEL TANK VENT TUBE SET PLATE |
![]() |
Align the mark of the set plate with the fuel suction tube.
| *a | Mark |
Install the set plate with the 8 bolts.
| 3. CONNECT FUEL PUMP TUBE SUB-ASSEMBLY |
![]() |
Push the fuel tube joint onto the plug of the fuel suction plate, then install the tube joint clip.
| *1 | Tube Joint Clip |
| *2 | Fuel Tube Joint |
| *3 | O-ring |
| *4 | Collar |
| *a | Correct |
| *b | Incorrect |
Connect the fuel pump connector.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. INSPECT FOR FUEL LEAK |
Check fuel pump operation.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester on.
Enter the following menus: Powertrain / Engine / Active Test / Control the Fuel Pump / Speed.
Check for pressure in the fuel inlet tube from the fuel line. Check that sounds of fuel flowing from the fuel tank can be heard. If no sounds can be heard, check the integration relay, fuel pump, ECM and wiring connectors.
Inspect for fuel leaks.
Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.
Turn the ignition switch off.
Disconnect the intelligent tester from the DLC3.
| 6. INSTALL REAR FLOOR SERVICE HOLE COVER |
![]() |
Install the rear floor service hole cover with new butyl tape.
![]() | Butyl Tape |
| 7. INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) |
![]() |
Engage the claw to install a new rear seat cushion lock hook.
| 8. INSTALL REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type) |
![]() |
Engage the claw to install a new rear seat cushion lock hook.
| 9. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) |
Place the rear seat cushion assembly in the cabin.
![]() |
Engage the 2 hooks of the rear seat cushion assembly to the vehicle body as shown in the illustration.
Confirm that the rear seat cushion assembly is firmly installed.
| 10. INSTALL REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) |
Place the rear seat cushion assembly in the cabin.
w/ Seat Heater System:
Connect the 2 seat heater connectors.
![]() |
Engage the 2 hooks of the rear seat cushion assembly to the vehicle body as shown in the illustration.
Confirm that the rear seat cushion assembly is firmly installed.