Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB

REAR AXLE HUB > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
  1. Install the rear axle hub and bearing assembly and parking brake assembly to the rear axle carrier sub-assembly with the 4 bolts.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }



2. INSPECT REAR AXLE HUB BEARING LOOSENESS


    C240543
  1. Using a dial indicator, check for looseness near the center of the rear axle hub.

    Maximum:
    0.05 mm (0.00197 in.)

    NOTICE:
    1. Ensure that the dial indicator is set perpendicular to the measurement surface.
    2. Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.

    If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.



3. INSPECT REAR AXLE HUB RUNOUT


    C240542
  1. Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolt.

    Maximum:
    0.07 mm (0.00276 in.)

    NOTICE:
    1. Ensure that the dial indicator is set perpendicular to the measurement surface.
    2. Make sure to install the tip of the dial indicator towards the outside of the rear axle hub bolt.
    3. Keep the magnet of the dial indicator away from the rear axle hub and bearing.

    If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.



4. CONNECT SKID CONTROL SENSOR WIRE
  1. Connect the connector to the rear speed sensor.



5. INSTALL REAR DISC


    C238505E01
  1. Align the matchmarks of the rear disc and rear axle hub, and install the rear disc.
    Text in Illustration 
    *a
    Matchmark

    NOTICE:
    When replacing the disc with a new one, select the installation position where the rear disc has minimal runout.



6. INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
  1. Install the parking brake shoe adjusting hole plug.



7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
  1. Install the rear disc brake caliper assembly with the 2 bolts.

    Torque:
    62 N*m{ 630 kgf*cm , 46 ft.*lbf }

  1. Install the rear flexible hose to the rear shock absorber assembly with the bolt.

    Torque:
    19 N*m{ 192 kgf*cm , 14 ft.*lbf }



8. ADJUST PARKING BRAKE
(Click here)


9. INSTALL REAR WHEEL

Torque:
103 N*m{ 1049 kgf*cm , 76 ft.*lbf }



10. CHECK FOR SPEED SENSOR SIGNAL
(Click here)