Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1300    Skid Control ECU Malfunction

for Preparation Click here


DESCRIPTION

The skid control ECU stores this DTC if malfunctions are found in the circuit inside the ECU by self diagnosis.

DTC No.
DTC Detection Condition
Trouble Area
C1300
Internal failure of the skid control ECU control unit.
Skid control ECU (Brake actuator assembly)

INSPECTION PROCEDURE

1.REPLACE BRAKE ACTUATOR ASSEMBLY
  1. Replace the skid control ECU (brake actuator assembly) (Click here).

    HINT:
    This DTC is output when the skid control ECU detects a malfunction in the internal circuit.

  1. Perform system variant learning (Click here).

  1. Perform the sensor check using the Test Mode procedure (Click here).


NEXT

END