Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER ACTUATOR

HEADLIGHT CLEANER ACTUATOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER ASSEMBLY
(Click here)


2. REMOVE HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY


    E227514
  1. Extend the headlight washer washer nozzle sub-assembly.

  1. Disengage the 2 claws and remove the headlight washer washer nozzle sub-assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



3. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY


    E227511
  1. Slide the clip and disconnect the headlight cleaner hose.



    E227510
  1. Remove the bolt.



  1. Push the tab (A) and disengage the claw and remove the headlight washer actuator sub-assembly as shown in the illustration.


    E227512E01

    HINT:
    Use the same procedure for the RH side and LH side.