Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › HARD DISK DRIVE

HARD DISK DRIVE > INSTALLATION

for Preparation Click here



1. PRECAUTION

NOTICE:
When installing the hard disc drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.



2. INSTALL HARD DISK DRIVE


    E223755
  1. Insert the hard disk drive as shown in the illustration.

  1. Engage the 2 guides to temporarily install the cover.

  1. Install the cover with the 2 screws.



3. INSTALL NO. 2 RADIO RECEIVER BRACKET
  1. Install the No. 2 radio receiver bracket with the 5 screws.



4. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY
  1. Connect each connector.

  1. Engage the 6 clips to the vehicle body to temporarily install the navigation receiver assembly with air conditioning control assembly.

  1. Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts.



5. INSTALL FRONT CONSOLE UPPER PANEL GARNISH


  1. for Blank Type:



      B284923
    1. Engage the 2 claws to install the front console upper panel garnish as shown in the illustration.



  1. for 3 Switch Hole Type:

    1. Connect each connector.



    2. B281753
    3. Engage the 2 claws to install the front console upper panel garnish as shown in the illustration.



6. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
  1. Connect the connector.



    B281760
  1. Engage the 4 clips to install the No. 2 instrument panel register assembly.

    NOTICE:
    When installing the No. 2 instrument panel register assembly, check that the wire harness is not caught between the No. 2 instrument panel register assembly and duct.



7. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B283351
  1. Engage the 7 clips and 2 guides to install the center instrument cluster finish panel sub-assembly.



8. INSTALL FRONT PANEL GARNISH RH


    B280333
  1. Engage the 3 clips and 8 guides to install the front panel garnish RH.



9. INSTALL FRONT PANEL GARNISH LH


    B281945
  1. Engage the 3 clips and 8 guides to install the front panel garnish LH.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



11. INSPECT HARD DISK DRIVE
(Click here)