Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > INSTALLATION

for Preparation Click here


HINT:
Perform "Inspection After Repair" after replacing the spark plug and ignition coil assembly (Click here).



1. INSTALL SPARK PLUG
  1. Using a spark plug wrench, install the 4 spark plugs.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    HINT:
    Perform "Inspection After Repair" after replacing the spark plug (Click here).



2. INSTALL IGNITION COIL ASSEMBLY
  1. Install the 4 ignition coil assemblies with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    HINT:
    Perform "Inspection After Repair" after replacing the ignition coil assembly (Click here).

  1. Connect the 4 ignition coil assembly connectors.



3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
  1. Fit the 3 retainers and install the No.1 engine cover sub-assembly.