Home › Engine / Hybrid System ยท 1AZ-FE › LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Warm up and stop the engine, then wait for 5 minutes.

  1. Check that the engine oil level is between the low level and full level mark on the engine oil level dipstick.
    If the level is low, check for leaks and add engine oil up to the full level mark.

    NOTICE:
    Do not fill the engine with engine oil to above the full level mark.



2. CHECK ENGINE OIL QUALITY
  1. Check the engine oil for deterioration, water contamination, discoloration or thinning.
    If the quality is visibly poor, replace the engine oil and oil filter sub-assembly.



3. CHECK OIL PRESSURE
  1. Remove the engine oil pressure switch assembly (Click here).



    A219564E02
  1. Install an oil pressure gauge with the adapter.
    Text in Illustration 
    *1
    Oil Pressure Gauge

  1. Install the air cleaner case sub-assembly .

  1. Install the air cleaner cap sub-assembly .

  1. Warm up the engine.

  1. Measure the engine oil pressure.

    Standard Oil Pressure:
    Condition
    Specified Condition
    Idle
    29 kPa (0.3 kgf/cm2, 4.2 psi) or more
    3000 rpm
    170 to 300 kPa (1.7 to 3.1 kgf/cm2, 25 to 44 psi)

    If the oil pressure is not as specified, check the oil pump assembly (Click here).

  1. Stop the engine.

  1. Remove the air cleaner cap sub-assembly .

  1. Remove the air cleaner case sub-assembly .

  1. Remove the oil pressure gauge with the adapter.

  1. Install the engine oil pressure switch assembly (Click here).

  1. Check for engine oil leaks.