STEERING LOCK SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Interview the customer and confirm the problem (Click here).
| |||||
| 3.CHECK BATTERY VOLTAGE |
| |||||
| 4.CHECK DTC* |
Check for DTCs and make a note of any codes that are output (Click here).
| Result | Proceed to |
| DTC is not output. (Problem symptom cannot be confirmed or reproduced.) | A |
| DTC is not output. (Problem symptom can be confirmed and reproduced.) | B |
| Steering lock system DTC is output. | C |
|
| ||||
|
| ||||
| |||||
| 5.SYMPTOM SIMULATION |
Proceed to How to Proceed with Troubleshooting (Click here).
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
Proceed to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table. | A |
| Fault is listed in Problem Symptoms Table. | B |
|
| ||||
| |||||
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Proceed to Data List / Active Test (Click here).
Proceed to Terminals of ECU (Click here).
|
| ||||
|---|---|---|---|---|---|
| 8.CIRCUIT INSPECTION* |
| |||||
| 9.REPAIR OR REPLACE |
| |||||
| 10.CHECK DTC AGAIN* |
Clear the DTCs (Click here).
Check for DTCs and make a note of any codes that are output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| Steering lock system DTC is output. | B |
|
| ||||
|
| ||||
|---|---|---|---|---|---|