Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1582    Assist Map Number Mismatch

for Preparation Click here


DESCRIPTION

When an incorrect ECM assembly is installed after the assist map has been written in the power steering ECU assembly, then DTC C1582 is stored because the data does not match the vehicle specifications.

DTC No.
DTC Detection Condition
Trouble Area
C1582
Assist map number mismatch
  1. CAN communication system
  2. Incorrect ECM
  3. Incorrect main body ECU (multiplex network body ECU)
  4. Incorrect brake actuator assembly (skid control ECU)
  5. Power steering ECU assembly

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTCs are not output
    A
    DTCs are output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK RELATED PART (ECM, MAIN BODY ECU AND SKID CONTROL ECU)
  1. Check if any of the parts listed below have been replaced with an incorrect part in the past.

    Related Part
    ECM
    Main body ECU (multiplex network body ECU)
    Brake actuator assembly (skid control ECU)

    NOTICE:
    When removing a related part to check it, be sure to follow the appropriate procedures and precautions.
    1. Refer to the following procedures to remove the ECM (for 2AR-FE) (Click here).
    2. Refer to the following procedures to remove the ECM (for 2GR-FE) (Click here).
    3. Refer to the following procedures to remove the Main body ECU (multiplex network body ECU) (Click here).
    4. Refer to the following procedures to remove the brake actuator assembly (skid control ECU) (Click here).

    HINT:
    1. DTC C1582 is stored when a part with an incorrect part number is installed for the related parts listed above.
    2. When DTC C1582 is output when parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.

Result 
Result
Result
Proceed to
Proceed to
All installed related parts have correct part number
A
Part with incorrect part number is installed
B


B
REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER
A

REPLACE POWER STEERING ECU ASSEMBLY (Click here)