CAN COMMUNICATION SYSTEM > Certification ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Certification ECU Communication Stop Mode | Either condition is met:
|
|


| 1.CHECK FOR OPEN IN CAN BUS LINES (SMART KEY ECU ASSEMBLY (CERTIFICATION ECU) BRANCH LINE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the smart key ECU assembly (certification ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I78-14 (CANH) - I78-15 (CANL) | Cable disconnected from negative (-) battery terminal | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Smart Key ECU Assembly (Certification ECU)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A43-11 (E) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |
Connect the cable to the negative (-) battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A43-2 (+B) - Body ground | Ignition switch off | 11 to 14 V |
| I78-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Rear view of wire harness connector (to Smart Key ECU Assembly (Certification ECU)) |
|
| ||||
| OK | ||
| ||