DTC B2341 Sensor (Motor) Failure |
DTC B2344 Position Failure |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2341 | Sensor (motor) failure (When the sliding roof ECU enters fail-safe mode due to a problem with the motor) |
|
| B2344 | Position failure (When the sliding roof ECU enters fail-safe mode due to a problem with the gear position) |
|

| 1.CHECK SLIDING ROOF OPERATION |
Check the sliding roof auto operation (Click here).
|
| ||||
| OK | |
| 2.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||
| 3.INITIALIZE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
Check that the sliding roof ECU (sliding roof drive gear sub-assembly) can be initialized (Click here).
|
| ||||
| OK | |
| 4.CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - SLIDING ROOF SWITCH AND BODY GROUND) |
Disconnect the S7 sliding roof switch (roof console box assembly) connector.
Disconnect the S4 sliding roof ECU (sliding roof drive gear sub-assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S4-5 (CLS) - S7-2 (CLS) | Always | Below 1 Ω |
| S4-5 (CLS) - Body ground | Always | 10 kΩ or higher |
| S4-7 (OPN) - S7-3 (OPN) | Always | Below 1 Ω |
| S4-7 (OPN) - Body ground | Always | 10 kΩ or higher |
| S4-6 (DWN) - S7-4 (DOWN) | Always | Below 1 Ω |
| S4-6 (DWN) - Body ground | Always | 10 kΩ or higher |
| S4-4 (UP) - S7-5 (UP) | Always | Below 1 Ω |
| S4-4 (UP) - Body ground | Always | 10 kΩ or higher |
| S7-1 (GND) - Body ground | Always | Below 1 Ω |
| S4-12 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 6.INSPECT SLIDING ROOF SWITCH (ROOF CONSOLE BOX ASSEMBLY) |
![]() |
Remove the sliding roof switch (roof console box assembly) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 5 (UP) - 1 (GND) | UP switch is pressed | Below 1 Ω |
| 5 (UP) - 1 (GND) | UP switch is not pressed | 10 kΩ or higher |
| 4 (DOWN) - 1 (GND) | DOWN switch is pressed | Below 1 Ω |
| 4 (DOWN) - 1 (GND) | DOWN switch is not pressed | 10 kΩ or higher |
| 3 (OPN) - 1 (GND) | OPEN switch is pressed | Below 1 Ω |
| 3 (OPN) - 1 (GND) | OPEN switch is not pressed | 10 kΩ or higher |
| 2 (CLS) - 1 (GND) | CLOSE switch is pressed | Below 1 Ω |
| 2 (CLS) - 1 (GND) | CLOSE switch is not pressed | 10 kΩ or higher |
| *a | Component without harness connected (Sliding Roof Switch (Roof Console Box Assembly)) |
|
| ||||
| OK | ||
| ||