Home › Engine / Hybrid System ยท 2AR-FE › INTAKE / EXHAUST › INTAKE AIR CONTROL VALVE ACTUATOR (for TCV)

INTAKE AIR CONTROL VALVE ACTUATOR (for TCV) > REMOVAL

for Preparation Click here



1. REMOVE INTAKE MANIFOLD
(Click here)


2. REMOVE INTAKE AIR CONTROL VALVE ACTUATOR (for TCV)


    A196059
  1. Remove the 2 bolts, intake air control valve actuator and gasket from the intake manifold.

    NOTICE:

    1. A203084
      Make sure that foreign matter, such as water, oil, sand or iron particles, does not enter the gear chamber or actuator at the locations marked by the circles in the illustration.

    2. A197294
      Do not loosen or remove the bolt and 2 nuts shown in the illustration.