Home › Engine / Hybrid System ยท 1AZ-FE › INTAKE / EXHAUST › INTAKE MANIFOLD

INTAKE MANIFOLD > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click here).



2. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)


3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY
(Click here)


5. DISCONNECT FUEL TUBE SUB-ASSEMBLY


    A261648
  1. Remove the No. 1 fuel pipe clamp.



    A261677E01
  1. Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.
    Text in Illustration 
    *1
    Fuel Pipe
    *2
    Fuel Tube Connector
    *3
    Nylon Tube
    *4
    O-ring
    *5
    Retainer
    V100135
    Pinch
    V100136
    Pull

    NOTICE:
    1. Check for foreign matter on the fuel tube around the fuel tube connector. Clean it if necessary. Foreign matter can affect the ability of the O-ring to seal the fuel tube connector and fuel pipe.
    2. Do not use any tools to separate the fuel tube connector and fuel pipe.
    3. Do not forcibly bend, kink or twist the nylon tube.
    4. Keep the fuel tube connector and fuel pipe free from foreign matter.
    5. If the fuel tube connector and fuel pipe are stuck, push and pull to release them.
    6. Cover the fuel tube connector and fuel pipe with plastic bags to prevent damage and contamination.



    A261678
  1. Remove the fuel tube sub-assembly from the fuel hose clamp.



6. DISCONNECT FUEL DELIVERY PIPE SUB-ASSEMBLY


    A261679
  1. Remove the 2 wire harness clamps.

  1. Disconnect the 4 fuel injector connectors.



    A183970
  1. Remove the 2 bolts, and then remove the fuel delivery pipe sub-assembly together with the 4 fuel injector assemblies.

    NOTICE:
    Be careful not to drop the fuel injector assemblies when removing the fuel delivery pipe sub-assembly.



    A147098
  1. Remove the 2 fuel delivery spacers from the cylinder head.

  1. Remove the 4 injector vibration insulators from the cylinder head.



7. DISCONNECT NO. 2 VENTILATION HOSE


    A262598
  1. Disconnect the No. 2 ventilation hose from the intake manifold.



8. DISCONNECT UNION TO VACUUM TUBE HOSE


    A264238
  1. Disconnect the union to vacuum tube hose from the intake manifold.



9. REMOVE INTAKE MANIFOLD


    A264229
  1. Disconnect the oxygen sensor connector and 2 wire harness clamps.



    A262603
  1. Remove the 5 bolts and 2 nuts, and separate the intake manifold.



    A264903
  1. Using an E7 "TORX" wrench, remove the 2 stud bolts.

  1. Remove the intake manifold.



    A090130
  1. Remove the No. 1 intake manifold to head gasket from the intake manifold.



    A262599
  1. Remove the bolt and vacuum hose clamp.