Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1419    Acceleration Sensor Internal Circuit

DTC    C1435    Yaw Rate Sensor Internal Circuit

for Preparation Click here


DESCRIPTION

These DTCs are stored when the skid control ECU receives an internal malfunction signal from the yaw rate and acceleration sensor (airbag sensor assembly).

DTC No.
DTC Detection Condition
Trouble Area
C1419
With the +BS terminal voltage 9.6 to 16.5 V, the acceleration sensor malfunction signal is received from the acceleration sensor.
Yaw rate and acceleration sensor (Airbag sensor assembly)
C1435
With the +BS terminal voltage 9.6 to 16.5 V, the yaw rate sensor malfunction signal is received from the yaw rate sensor.
Yaw rate and acceleration sensor (Airbag sensor assembly)

INSPECTION PROCEDURE

1.REPLACE AIRBAG SENSOR ASSEMBLY
  1. Replace the yaw rate and acceleration sensor (airbag sensor assembly) (Click here).

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (Click here).


NEXT

END