Home › Engine / Hybrid System ยท 1AZ-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
(Click here)


2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A264395E01
  1. Using SST, hold the crankshaft pulley.
    Text in Illustration 
    *a
    Hold

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A264396
  1. Remove the 8 bolts, the front drive plate spacer, the drive plate and ring gear sub-assembly, and the rear drive plate spacer.



3. REMOVE REAR ENGINE OIL SEAL


    A128873E09
  1. Using a knife, cut off the lip of the rear engine oil seal.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Cut Position

  1. Using a screwdriver, pry out the rear engine oil seal.

    NOTICE:
    1. Tape the screwdriver tip before use.
    2. Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.