Home › Engine / Hybrid System ยท 2GR-FE › INTAKE / EXHAUST › INTAKE AIR CONTROL VALVE (for ACIS)

INTAKE AIR CONTROL VALVE (for ACIS) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT INTAKE AIR CONTROL VALVE (for ACIS)
  1. Perform the following inspection procedure when using the intelligent tester:

    1. Stop the engine.

    2. Remove the V-bank cover assembly .

    3. Connect the intelligent tester to the DLC3.

    4. Start the engine and turn the intelligent tester on.

    5. Enter the following menus: Powertrain / Engine and ECT / Active Test / Active the VSV for Intake Control.

    6. Make sure that a clicking sound is heard from the intake air control valve when current flows.
      If the intake air control valve does not operate, check the ACIS control circuit (Click here).

    7. Install the V-bank cover assembly .



  1. Perform the following inspection procedure when applying voltage between the terminals:

    1. Remove the V-bank cover assembly .



    2. A179194E01
    3. Disconnect the connector from the intake air control valve.



    4. A129502
    5. Apply battery voltage between terminals 2 (+) and 1 (-) of the intake air control valve. Check that a clicking sound is heard from the intake air control valve.
      If the operation is not as specified, replace the intake air surge tank assembly.

    6. Install the V-bank cover assembly .