Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM

PARKING ASSIST MONITOR SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



PARKING ASSIST MONITOR DIAGNOSIS SYSTEM
  1. For parking assist monitor system diagnosis, signals received by the navigation ECU sub-assembly can be checked and the parking assist monitor system can be calibrated, adjusted and checked using the navigation ECU sub-assembly.

    NOTICE:
    Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).

    HINT:
    The displayed items may differ depending on vehicle specifications.


DIAGNOSIS SCREEN TRANSITION (during parking assist monitor system initialization)

E226186E01


E226187


DIAGNOSIS SCREEN TRANSITION (after parking assist monitor system initialization)

E226188E01


E226189


VEHICLE SIGNAL CHECK
  1. Start diagnostic mode (Click here).



  2. E226190
  3. Select "Function Check/Setting" on the Service Menu screen to display the Function Check/Setting screen.



  4. E226193
  5. Select "Vehicle Signal" on the Function Check/Setting screen.



  6. E225776
  7. Vehicle Signal Check Mode

    1. When the "Vehicle Signal Check Mode" screen is displayed, check "REV" the vehicle signal conditions.

      HINT:
      1. Only conditions having inputs are displayed.
      2. This screen displays vehicle signals input to the navigation ECU sub-assembly.
      3. For details of this function, refer to Diagnosis Display Detailed Description in System Description (Click here)

  8. Finish diagnostic mode (Click here).


CAR SIGNAL CHECK (parking assist monitor system input signals)


  1. Start diagnostic mode (Click here).



      E226190
    1. Select "Function Check/Setting" on the Service Menu screen to display the Function Check/Setting screen.



    2. E226193
    3. Select "Camera Setting" on the Function Check/Setting screen.



    4. E226194
    5. Select "Next" on the Car Information Check screen.

      HINT:
      After "Next" is selected, the screen transitions differ depending on whether initialization of the parking assist monitor system was performed after the navigation ECU sub-assembly was replaced.
      Parking Assist Monitor System Initialization
      Screen Transition
      Not performed
      Car Signal Check screen
      Performed
      Mode Setting screen



    6. E233966
    7. When the screen changes to the Mode Setting screen, select "Back Camera Setting" to display the Car Signal Check screen.

      HINT:
      To select a grayed out item, select and hold the item for 2 seconds or more.



  2. E233967
  3. Car Signal Check

    1. On the Car Signal Check screen, it is possible to inspect the state of signals and check the settings.

      Item
      Inspection Detail
      Note
      BCTY
      Luggage compartment door courtesy light switch signal input
      When "CHK" (red) is displayed, selecting "Next" will not change to the next screen.

      HINT:
      1. When "CHK" (red) is displayed, perform inspections based on the result of the following inspections.
      2. If performing the adjustment after proceeding to the next screen, confirm that all items display "OK" (blue) before selecting "Next".

  4. BCTY inspection

    HINT:
    If "CHK" (red) is displayed for "BCTY", check for DTCs and perform troubleshooting based on the output DTCs (Click here).

  5. Finish diagnostic mode (Click here).


CALIBRATION WHEN SERVICING VEHICLE

NOTICE:
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).