Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › BLOCKING SYSTEM

DTC    B15C0    Short in GPS Antenna

DTC    B15C1    Open in GPS Antenna

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the instrument panel integration antenna assembly (GPS antenna) circuit.

DTC No.
DTC Detection Condition
Trouble Area
B15C0
There is a short circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and instrument panel integration antenna assembly (GPS antenna), or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly.
  1. Telephone transceiver assembly
  2. Instrument panel integration antenna assembly (GPS antenna)
B15C1
There is an open circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and instrument panel integration antenna assembly (GPS antenna), or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly.

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the telephone transceiver assembly or instrument panel integration antenna assembly, refer to the Service Bulletin.
  2. When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.

1.CHECK CONNECTION OF CONNECTOR
  1. Turn the engine switch off.

  1. Check that the connectors are properly connected to the telephone transceiver assembly and instrument panel integration antenna assembly (GPS antenna).

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


2.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Check for DTCs (Click here).

    OK:
    DTC B15C0 and B15C1 are not output.



NG
Go to step 4
OK

END 

4.CHECK CONNECTOR CONDITION
  1. Turn the engine switch off.

  1. Disconnect the instrument panel integration antenna assembly (GPS antenna) connector [color: blue].

  1. Check that the connector pins are not bent.

    OK:
    Connector pins are not bent.



NG
REPAIR OR REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY
OK


5.CHECK INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY


    B255161E01
  1. Disconnect the instrument panel integration antenna assembly (GPS antenna) connector [color: blue].

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Core wire - Shield
    Always
    50 to 500 Ω

    Text in Illustration 
    *1
    Core wire
    *2
    Shield
    *a
    Component without harness connected
    (Instrument Panel Integration Antenna Assembly (GPS Antenna))



NG
REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY
OK


6.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


7.CHECK DTC OUTPUT
  1. Check for DTCs (Click here).

    OK:
    DTC B15C0 and B15C1 is not output.



NG
Go to step 8
OK

END 

8.REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY
  1. Temporarily replace the instrument panel integration antenna assembly with a new or known good one.

    HINT:
    Refer to the Service Bulletin.


NEXT


9.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


10.CHECK DTC OUTPUT
  1. Check for DTCs (Click here).

    OK:
    DTC B15C0 and B15C1 is not output.



NG
REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
OK

END (INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY WAS DEFECTIVE)