Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › BLOCKING SYSTEM

DTC    B1573    Short in Telephone Antenna Circuit

DTC    B15CB    Telematics Transceiver Antenna Disconnected

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the instrument panel integration antenna assembly (telephone antenna) circuit.

DTC No.
DTC Detection Condition
Trouble Area
B1573
There is a short circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and telephone antenna, or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly.
  1. Telephone transceiver assembly
  2. Instrument panel integration antenna assembly (telephone antenna)
B15CB
There is an open circuit in the instrument panel integration antenna assembly between the telephone transceiver assembly and telephone antenna, or at the points where it connects to the telephone transceiver assembly and instrument panel integration antenna assembly.

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the telephone transceiver assembly or instrument panel integration antenna assembly, refer to the Service Bulletin.
  2. When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.

1.CHECK CONNECTION OF CONNECTOR
  1. Turn the engine switch off.

  1. Check that the connectors are properly connected to the telephone transceiver assembly and instrument panel integration antenna assembly (telephone antenna connector).

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


2.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Check for DTCs (Click here).

    OK:
    DTC B1573 and B15CB is not output.



NG
Go to step 4
OK

END 

4.CHECK CONNECTOR CONDITION
  1. Turn the engine switch off.

  1. Disconnect the instrument panel integration antenna assembly (telephone antenna) connector [color: wine red].

  1. Check that the connector pins are not bent.

    OK:
    Connector pins are not bent.



NG
REPAIR OR REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY
OK


5.CHECK INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY (TELEPHONE ANTENNA)


    B255162E02
  1. Disconnect the instrument panel integration antenna assembly (telephone antenna) connector [color: wine red].

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Core wire - Shield
    Always
    4 to 11 kΩ

    Text in Illustration 
    *1
    Core wire
    *2
    Shield
    *a
    Component without harness connected
    (Instrument Panel Integration Antenna Assembly (Telephone Antenna))



NG
REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY
OK


6.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


7.CHECK DTC OUTPUT
  1. Wiggle the instrument panel integration antenna assembly (telephone antenna).

  1. Check for DTCs (Click here).

    OK:
    DTC B1573 and B15CB is not output.



NG
Go to step 8
OK

END 

8.REPLACE INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY
  1. Temporarily replace the instrument panel integration antenna assembly with a new or known good one.

    HINT:
    Refer to the Service Bulletin.


NEXT


9.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


10.CHECK DTC OUTPUT
  1. Check for DTCs (Click here).

    OK:
    DTC B1573 and B15CB is not output.



NG
REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
OK

END (INSTRUMENT PANEL INTEGRATION ANTENNA ASSEMBLY WAS DEFECTIVE)