Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1224    NE Signal

for Preparation Click here


DESCRIPTION

The skid control ECU receives the engine speed signals from the ECM via the CAN communication system.

DTC No.
DTC Detection Condition
Trouble Area
C1224
The vehicle speed is 6 km/h (4 mph) or more, the +BS terminal voltage is between 9.6 and 16.5 V, and the engine speed signal is more than 12800 rpm for 2.5 seconds or more.
  1. CAN communication system
  2. ECM

INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK SFI SYSTEM
  1. Check if an SFI system DTC is output (Click here for 2GR-FE, Click here for 2AR-FE, or Click here for 1AZ-FE).

    Result:

    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
INSPECT SFI SYSTEM
A

REPLACE ECM