Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B14B3    Lost Communication with Rear Panel LIN

for Preparation Click here


DESCRIPTION

The cooler control switch assembly communicates with the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the cooler control switch assembly is operated.

DTC No.
DTC Detection Condition
Trouble Area
B14B3
Lost communication with the cooler control switch assembly.
  1. Harness or connector between cooler control switch assembly and IG circuit
  2. Harness or connector between cooler control switch assembly and body ground
  3. LIN communication system
  4. Cooler control switch assembly
  5. Air conditioning amplifier assembly

WIRING DIAGRAM


E226613E05


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (COOLER CONTROL SWITCH ASSEMBLY - IG CIRCUIT)
  1. Disconnect the X1 cooler control switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    X1-7 (IG+) - Body ground
    Ignition switch off
    Below 1 V
    X1-7 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (COOLER CONTROL SWITCH ASSEMBLY - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    X1-16 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - COOLER CONTROL SWITCH ASSEMBLY)
  1. Disconnect the I77 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    X1-10 (RLIN) - I77-37 (LIN1)
    Always
    Below 1 Ω
    X1-10 (RLIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE COOLER CONTROL SWITCH ASSEMBLY
  1. Replace the cooler control switch assembly (Click here).

    HINT:
    Since the cooler control switch assembly cannot be inspected while it is removed from the vehicle, replace the cooler control switch assembly with a new or a known good one and check that the condition returns to normal.

OK:
Cooler control switch assembly operation returns to normal.


Result:

Result
Proceed to
OK
A
NG (When troubleshooting according to Problem Symptoms Table)
B
NG (When troubleshooting according to the DTC)
C



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
A

END (COOLER CONTROL SWITCH ASSEMBLY WAS DEFECTIVE)