CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Select the following menu items: Body Electrical / Combination Meter / Active Test.
Check the cruise control indicator light by performing the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Cruise | Cruise control indicator light | Cruise control indicator light (illuminated in green) ON / OFF | - |
| Cruise Indicator* | Cruise control indicator light | Cruise control indicator light (illuminated in amber) ON / OFF | - |
|
| ||||
| OK | ||
| ||