Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER

COMBINATION METER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    B278007
  1. Disconnect the front door opening trim weatherstrip LH.



4. REMOVE INSTRUMENT SIDE PANEL LH


    B278008
  1. Using a moulding remover, disengage the 4 claws as shown in the illustration.



    B278010
  1. Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.



5. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B278012
  1. Disengage the 3 clips to remove the No. 1 instrument cluster finish panel garnish as shown in the illustration.



6. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    B278013E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B279858
  1. Disengage the 2 clips as shown in the illustration.



    B279859
  1. Using a moulding remover, disengage the 2 clips to remove the No. 1 instrument panel register assembly.



7. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
  1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.



    B279860
  1. Using a moulding remover, disengage the 2 claws, 4 clips and 2 guides.



    B279862
  1. Disengage the 5 claws, 5 clips and 2 guides.

  1. Disconnect each connector.



    B279863
  1. Remove the instrument cluster finish panel assembly as shown in the illustration.



8. REMOVE COMBINATION METER ASSEMBLY


    E226414
  1. Remove the 4 screws.



    E223142
  1. Disengage the wire harness clamp.

  1. Disconnect the 2 connectors to remove the combination meter assembly.