Process
| Procedure
|
1. Start of registration
| - Connect the Techstream to DLC3
- While holding the registered key, turn the engine switch on (IG)
- Turn the Techstream on
- Enter the following menus: Smart Key / Utility / ECU Communication ID Registration / Remote Engine Starter
|
2. Confirmation of registered key*
| - Touch the logo of registered key to the engine switch (for details, refer to Description of Registration)
- Confirm that the wireless door lock buzzer sounds once (short beep)
|
3. Erasure of ECU code
| - Perform operation according to prompts on the Techstream screen
|
4. End of registration
| - Finish remote engine starter ID registration
|