Home › Engine / Hybrid System ยท 2AR-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
  1. Apply gasoline to 2 new O-rings and then install them to the fuel pressure regulator assembly.



2. INSTALL FUEL PUMP


    A192863E07
  1. Apply gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.
    Text in Illustration 
    *1
    O-ring
    *2
    Spacer



    A192527E01
  1. Engage the 5 claws of the fuel pump.
    Text in Illustration 
    *1
    Fuel Filter
    *2
    Suction Filter

    NOTICE:
    1. Make sure that the O-ring is not cut or pinched during the installation.
    2. Engage the claws securely.
    3. Do not remove the suction filter.

    HINT:
    Perform "Inspection After Repair" after replacing the fuel pump assembly (Click here).



    A254943
  1. Engage the 2 claws of the No. 1 fuel suction support.

  1. Connect the fuel pump harness connector.



    A159104
  1. Engage the 2 claws of the No. 1 fuel suction support and install the fuel filter and the fuel pump onto the fuel sub-tank.



    A254941
  1. Align the groove of the fuel pump filter hose with the cutout of the fuel sub-tank and install the hose.

    NOTICE:
    Do not apply excessive force to the fuel tube or the suction support.

  1. Connect the connector of the fuel pump harness.



3. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A254932E02
  1. Install the fuel sender gauge assembly by sliding it downward.

  1. Connect the connector of the fuel sender gauge assembly.

  1. Install the harness protector.

    NOTICE:
    Do not damage the wire harness.



    A252641
  1. Connect the 3 harness clamps.

    NOTICE:
    Do not damage the wire harness.



4. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(Click here)