FUEL PUMP > INSTALLATION |
| 1. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY |
![]() |
Install a new fuel suction tube set gasket to the fuel suction tube.
| *1 | Fuel Suction Tube Set Gasket |
| *2 | Fuel Cut-off Tube |
Push in the fuel cut-off tube connector to the fuel suction tube assembly and push the retainer so that the claws engage.
Install the fuel suction tube with pump and gauge assembly to the fuel tank.
| 2. INSTALL FUEL TANK VENT TUBE SET PLATE |
![]() |
Align the protrusion of the fuel suction tube assembly and the cutout of the fuel tank vent tube set plate.
| *1 | Cutout |
| *2 | Protrusion |
Install the set plate with the 8 bolts.
| 3. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Push the fuel tube joint in the plug of the fuel suction plate, then install the tube joint clip.
| *1 | Tube Joint Clip |
| *2 | Fuel Tube Joint |
| *3 | O-ring |
| *4 | Collar |
| *a | CORRECT |
| *b | INCORRECT |
| 4. CONNECT FUEL TANK BREATHER ELBOW TUBE SUB-ASSEMBLY |
![]() |
Push the fuel tube joint in the plug of the fuel suction plate, then install the tube joint clip.
| *1 | Tube Joint Clip |
| *2 | Fuel Tube Joint |
| *3 | O-ring |
| *4 | Collar |
| *a | CORRECT |
| *b | INCORRECT |
| 5. CONNECT FUEL TANK VENT HOSE |
![]() |
Push in the fuel tank vent hose connector to the fuel suction tube assembly and push the retainer so that the claws engage.
| *1 | Retainer |
Connect the fuel pump connector.
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. INSPECT FOR FUEL LEAK |
Check fuel pump operation.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Powertrain / Engine / Active Test / Control the Fuel Pump / Speed.
Check for pressure in the fuel inlet tube from the fuel line. Check that sounds of fuel flowing from the fuel tank can be heard. If no sounds can be heard, check the integration relay, fuel pump, ECM and wiring connectors.
Inspect for fuel leaks.
Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.
Turn the ignition switch off.
Disconnect the Techstream from the DLC3.
| 8. INSTALL REAR FLOOR SERVICE HOLE COVER |
![]() |
Install the rear floor service hole cover with new butyl tape.
![]() | Butyl Tape |
| 9. INSTALL REAR SEAT CUSHION LOCK HOOK |
![]() |
Engage the claw to install a new rear seat cushion lock hook.
| 10. INSTALL REAR SEAT CUSHION ASSEMBLY |
Place the rear seat cushion assembly in the cabin.
![]() |
Engage the 2 hooks of the seat cushion to the vehicle body as shown in the illustration.
Confirm that the seat cushion is firmly installed.