DTC B1446/46 Air Mix Damper Control Servo Motor Circuit (Driver Side) |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1446/46 | Air mix damper position sensor value does not change even if air conditioning amplifier assembly operates No. 2 air conditioning radiator damper servo sub-assembly (air mix (for driver side)) |
|

| 1.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Operate the driver side temperature adjustment switch.
Enter the following menus: Body Electrical / Air Conditioner / Data List.
Check the value(s) by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Air Mix Servo Actual Pulse(D) | No. 2 air conditioning radiator damper servo sub-assembly (air mix (for driver side)) actual pulse / Min.: 0, Max.: 255 | MAX COLD: 5 (pulse) MAX HOT: 103 (pulse) | - |
| Result | Proceed to |
| NG | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC) | C |
|
| ||||
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test.
Check the operation by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Air Mix Servo Targ Pulse(D) | No. 2 air conditioning radiator damper servo sub-assembly (air mix (for driver side)) pulse | Min.: 0, Max.: 255 | Operates between 5 and 103 pulses |
|
| ||||
| OK | ||
| ||
| 3.REPLACE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (AIR MIX (FOR DRIVER SIDE)) |
Replace the No. 2 air conditioning radiator damper servo sub-assembly (air mix (for driver side)) (Click here).
Check for the DTC.
| Result | Proceed to |
| DTC B1446/46 is output | A |
| DTC B1446/46 is not output | B |
|
| ||||
| A | |
| 4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY |
Replace the air conditioning harness assembly (Click here).
Check for the DTC.
| Result | Proceed to |
| DTC B1446/46 is output | A |
| DTC B1446/46 is not output | B |
|
| ||||
| A | ||
| ||