STEERING PAD > INSTALLATION |
| 1. INSTALL HORN BUTTON ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Connect the 2 airbag connectors to the horn button assembly.
| *1 | Airbag Connector |
| *2 | Horn Connector |
| *3 | Airbag Connector Lock |
Push in the 2 locks to install the 2 airbag connectors.
Connect the horn connector to the horn button assembly.
![]() |
Push the horn button assembly to engage the 3 pins carefully.
| 2. INSTALL LOWER NO. 3 STEERING WHEEL COVER |
Engage the claw and guide to install the lower No. 3 steering wheel cover.
| 3. INSTALL LOWER NO. 2 STEERING WHEEL COVER |
Engage the claw and guide to install the lower No. 2 steering wheel cover.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. INSPECT HORN BUTTON ASSEMBLY |
Make sure that the horn sounds.
If the horn does not sound, inspect the horn system (Click here).
| 6. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 7. INSPECT SRS WARNING LIGHT |