REPAIR INSTRUCTION > INITIALIZATION |
| PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED |
| Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | See page |
| Correct the steering angle neutral point | Parking assist monitor system |
Click here
|
| PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED |
| Replacement Part | Necessary Procedure | Effect/Inoperative Function when Necessary Procedures are not Performed | See page | |
| ECM | Vehicle Identification Number (VIN) registration | MIL comes on |
Click here for 2AR-FE Click here for 2GR-FE | |
| ECU communication ID registration (Engine immobiliser system) | Engine start |
Click here*1 Click here*2 | ||
| Inspection after repair | Poor idle, engine starting, etc |
Click here for 2AR-FE Click here for 2GR-FE | |
| Automatic transaxle assembly |
|
|
Click here for U660E Initialization Click here for U660E Registration | |
|
|
| ||
| Shift solenoid valve SL1 and/or SL2 | Perform road test to allow TCM to learn |
| ||
| TCM (If possible, read the transaxle compensation code from the previous TCM) | Possible |
|
| |
| Impossible |
|
| ||
| Automatic transaxle assembly |
|
|
Click here for U760E Initialization Click here for U760E Registration | |
|
|
| ||
| Shift solenoid valve SL1 and/or SL2 | Perform road test to allow ECM to learn |
| ||
| ECM (If possible, read the transaxle compensation code from the previous ECM) | Possible |
|
| |
| Impossible |
|
| ||
| Door control and tire pressure monitoring system receiver assembly |
|
|
Click here for Initialization Click here for Registration | |
| Code registration (Wireless door lock system) | Wireless door lock control system |
Click here
| ||
|
|
|
Click here for Initialization Click here for Registration | |
| Skid control ECU (Brake actuator assembly) | Perform system variant learning |
|
Click here
| |
| Power steering ECU assembly |
|
|
Click here*3 Click here*4 Click here*5 | |
| Electric power steering column sub-assembly (containing the torque sensor)*3*4 | Torque sensor zero point calibration | Steering effort is different between turning steering wheel to left and right | ||
|
| Parking assist monitor system |
Click here
| |
| Radio and display receiver assembly | Radio and display receiver assembly initialization | Parking assist monitor system | ||
| Rear television camera assembly | Back camera position setting | Parking assist monitor system | ||
| Re-registration of codes in the garage door opener system
| Garage door opener system |
Click here
| |
| DCM (Telematics Transceiver) | DCM activation | Safety connect system |
Click here
| |
| Code registration (Engine immobiliser system) |
|
Click here
| |
| Code registration (Engine immobiliser system) | Engine start |
Click here
| |
| Code registration (Wireless door lock system) | Wireless door lock control system |
Click here
| |
| Registration of remote engine starter ID (Remote engine starter system) | Remote engine start |
Click here
| |
| Zero point calibration and sensitivity check. (Occupant classification system) |
|
Click here
| |
| Initialization servo motor (Air conditioning system) | DTCs are output |
Click here*8 Click here*9 | |
| Initialize power window control system |
|
Click here
| |
| Initialize sliding roof ECU (pulse sensor initial position setting) |
|
Click here
| |
| Headlight leveling ECU assembly | Perform headlight leveling ECU assembly initialization | Headlight leveling function |
Click here
| |
| Rear height control sensor sub-assembly | Perform headlight leveling ECU assembly initialization | Headlight leveling function | ||