SIDE AIRBAG SENSOR (for Rear Side) > INSTALLATION |
| 1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

| *a | Correct | *b | Incorrect |
Insert the pin (stopper) into the body hole and install the side airbag sensor assembly to the vehicle body with the bolt.

| *1 | White housing lock | - | - |
| *a | Slide | - | - |
Connect the connector to the side airbag sensor assembly.
Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).
Check that there is no looseness in the installation parts of the side airbag sensor assembly.
| 2. INSTALL CENTER PILLAR LOWER GARNISH |
Engage the 2 claws and 3 clips to install the center pillar lower garnish LH.
| 3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP |
| 4. INSTALL REAR DOOR SCUFF PLATE |
Engage the 6 claws to install the rear door scuff plate LH.
| 5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP |
| 6. INSTALL FRONT DOOR SCUFF PLATE |
Engage the 10 claws to install the front door scuff plate LH.
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. PERFORM DIAGNOSTIC SYSTEM CHECK |
| 9. INSPECT SRS WARNING LIGHT |