Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY (for Front Passenger Side)

KNEE AIRBAG ASSEMBLY (for Front Passenger Side) > INSTALLATION

for Preparation Click here



1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    B279742E01
  1. Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.

    NOTICE:
    When connecting any airbag connector, take care not to damage the airbag wire harness.

    Text in Illustration 
    *1
    Airbag Connector
    *2
    Airbag Connector Lock

  1. Push in the lock to install the airbag connector.

  1. Temporarily install the lower No. 2 instrument panel airbag assembly with the 3 claws.

  1. Install the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.



2. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Engage the 2 guides and 4 claws to install the No. 2 instrument panel under cover sub-assembly.



3. INSTALL INSTRUMENT SIDE PANEL RH
  1. Engage the 3 guides.



    B279884
  1. Engage the 4 claws to install the instrument side panel RH as shown in the illustration.



4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH


5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side .



6. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and LH side .



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. PERFORM DIAGNOSTIC SYSTEM CHECK
for Separate Type Yaw Rate Sensor: (Click here)
for Built-in Type Yaw Rate Sensor: (Click here)


9. INSPECT SRS WARNING LIGHT
for Separate Type Yaw Rate Sensor: (Click here)
for Built-in Type Yaw Rate Sensor: (Click here)