Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM


C249284E01


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
  3. When replacing the tire pressure warning ECU and receiver on vehicles equipped with the wireless door lock control system (w/o smart key system), be sure to perform Registration of Recognition Code to register the transmitter IDs after ECU replacement (Click here).

HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (ECU - BATTERY AND BODY GROUND)


    C239106E04
  1. Disconnect the O25 or O33 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    O25-1 (IG) - Body ground*1
    O33-1 (IG) - Body ground*2
    Ignition switch ON
    10 to 16 V
    Ignition switch off
    Below 1 V

    1. *1: w/ Wireless Door Lock Control System
    2. *2: w/o Wireless Door Lock Control System

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O25-12 (GND) - Body ground*1
    O33-12 (GND) - Body ground*2
    Always
    Below 1 Ω

    1. *1: w/ Wireless Door Lock Control System
    2. *2: w/o Wireless Door Lock Control System
    Text in Illustration 
    *A
    w/ Wireless Door Lock Control System
    *B
    w/o Wireless Door Lock Control System
    *a
    Front view of wire harness connector
    (to Tire Pressure Warning ECU and Receiver)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER (Click here)