Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER

TIRE PRESSURE WARNING RECEIVER > REMOVAL

for Preparation Click here



HINT:
The type of tire pressure warning ECU and receiver used on this model differs according to the specifications of the vehicles. The expressions listed in the table below are used in this section.

Vehicle Specification
Part Name in Manual
Actual Part Name
w/ Wireless door lock control system
Tire pressure warning ECU and receiver
Door control and tire pressure monitoring system receiver assembly
w/o Wireless door lock control system
Tire pressure monitor receiver assembly



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing.
for Separate Type Yaw Rate Sensor: (Click here)
for Built-in Type Yaw Rate Sensor: (Click here)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE REAR SEAT CUSHION ASSEMBLY


  1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.




      B279202E01
    1. Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
      Standard Measurement 
      a
      100 mm (3.94 in.) or less

    2. Repeat the step above for the other hook.

  1. Remove the rear seat cushion assembly.



4. REMOVE REAR SEAT CUSHION LOCK HOOK


    B279203
  1. Disengage the claw and remove the rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the RH side and the LH side.



5. REMOVE REAR SIDE SEATBACK ASSEMBLY RH
  1. Disconnect the rear seat outer belt from the rear seat shoulder belt guide.

  1. Disconnect the connector.



    B285009
  1. Remove the 2 bolts.

  1. Disengage the hook and remove the rear side seatback assembly RH.



6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
  1. Disconnect the rear door opening trim weatherstrip RH.



7. REMOVE ROOF SIDE INNER GARNISH RH

HINT:
Use the same procedure as for the LH side .



8. REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER


    C236170
  1. Remove the bolt.

  1. Disengage the 2 tabs from the holes to remove the tire pressure warning ECU and receiver.



    C236171
  1. Disconnect the connector from the tire pressure warning ECU and receiver.