Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Light Circuit

for Preparation Click here


DESCRIPTION

If the tire pressure warning ECU and receiver detects any problems, the tire pressure warning light blinks (stays on after blinking for 1 minute) and tire pressure monitoring is cancelled at the same time. At this time, the ECU stores a DTC in memory.
Connecting terminals TC and CG of the DLC3 makes the tire pressure warning light blink to output DTCs.
The tire pressure warning ECU and receiver sends the tire pressure warning light illumination request signal to the main body ECU (multiplex network body ECU) via a direct line. The main body ECU (multiplex network body ECU) then sends the signal to the combination meter assembly via CAN communication.

WIRING DIAGRAM


C249402E01


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
  3. When replacing the tire pressure warning ECU and receiver on vehicles equipped with the wireless door lock control system (w/o smart key system), be sure to perform Registration of Recognition Code to register the transmitter IDs after ECU replacement (Click here).

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
  1. Check if a CAN communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK DTC OUTPUT (B1247)
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON.

  1. Check for DTCs (Click here).

    OK:
    DTC B1247 is not output.



NG
GO TO DTC B1247 (Click here)
OK


3.CHECK OPERATION OF TIRE PRESSURE WARNING LIGHT (ACTIVE TEST)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. Check the condition of the tire pressure warning light by using the Techstream.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Tire Pressure Warning System
    Tire pressure warning light
    Tire pressure warning light OFF or ON
    Confirm that the vehicle is stopped, engine idling

    OK:
    The tire pressure warning light turns on or off in accordance with the Techstream operation.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER (Click here)