STARTER > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 7 clips and cool air intake duct seal.
| 4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.
| 5. REMOVE INLET AIR CLEANER ASSEMBLY |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the vacuum switching valve assembly from the air cleaner hose.
![]() |
Disconnect the mass air flow meter connector and 2 wire harness clamps from the air cleaner cap sub-assembly.
![]() |
Separate the fuel vapor feed hose from the air cleaner hose.
![]() |
Disconnect the ventilation hose from the cylinder head cover.
![]() |
Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.
![]() |
Release the 2 clamps and remove the air cleaner cap sub-assembly.
| 7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| 8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.
Remove the 2 bolts and air cleaner case sub-assembly.
| 9. REMOVE BATTERY |
![]() |
Loosen the nut, and separate the positive (+) battery terminal.
Loosen the nut, and remove the bolt and battery clamp.
Remove the battery and battery tray.
| 10. REMOVE STARTER ASSEMBLY |
![]() |
Disconnect the starter connector.
Open the terminal cap, remove the nut and disconnect the starter wire.
![]() |
Remove the 2 bolts and starter.