STARTER > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 7 clips and cool air intake duct seal.
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.
| 5. REMOVE INLET NO. 2 AIR CLEANER |
![]() |
Disconnect the 2 wire harness clamps and vacuum hose clamp.
Remove the 2 bolts and inlet No. 2 air cleaner.
| 6. REMOVE BATTERY |
![]() |
Disconnect the positive (+) cable from the positive (+) battery terminal.
Loosen the nut and remove the bolt.
Remove the battery and battery tray.
| 7. REMOVE INLET NO. 1 AIR CLEANER |
![]() |
Disengage the pin and remove the inlet No. 1 air cleaner.
| 8. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the mass air flow meter connector and wire harness clamp.
![]() |
Disconnect the 3 hoses.
Separate the ventilation hose.
![]() |
Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.
Release the 2 clamps and remove the air cleaner cap with hose.
| 9. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| 10. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.
Remove the 2 bolts and air cleaner case sub-assembly.
| 11. REMOVE STARTER ASSEMBLY |
![]() |
Disconnect the starter connector.
Remove the terminal cap.
Remove the nut and disconnect the starter wire.
![]() |
Remove the 2 bolts and starter.