TRANSMISSION CONTROL CABLE > REMOVAL |
| 1. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 7 clips and cool air intake duct seal.
| 2. REMOVE INLET NO. 2 AIR CLEANER |
![]() |
Disconnect the 2 wire harness clamps and vacuum hose clamp.
Remove the 2 bolts and inlet No. 2 air cleaner.
| 3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the mass air flow meter connector and wire harness clamp.
![]() |
Disconnect the 3 hoses.
Separate the ventilation hose.
![]() |
Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.
Release the 2 clamps and remove the air cleaner cap with hose.
| 4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| 5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.
Remove the 2 bolts and air cleaner case sub-assembly.
| 6. REMOVE AIRBAG SENSOR ASSEMBLY |
| 7. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY |
![]() |
Disconnect the accelerator pedal sensor assembly connector.
Remove the 2 bolts and accelerator pedal sensor assembly.
| 8. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY |
Turn back the floor carpet.
![]() |
Remove the bolt and nut, and disconnect the No. 1 parking brake cable assembly.
| 9. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY |
Move the shift lever to N.
![]() |
Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.
Disengage the 2 claws and disconnect the transmission control cable assembly from the lower shift lever assembly.
![]() |
Disconnect the wire harness clamp.
![]() |
Remove the nut and clip, and disconnect the transmission control cable assembly.
![]() |
Turn back the dash panel insulator.
Remove the 2 bolts and pull out the transmission control cable assembly from the body.