TRANSMISSION CONTROL CABLE > REMOVAL |
| 1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.
| 2. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 7 clips and cool air intake duct seal.
| 3. REMOVE INLET AIR CLEANER ASSEMBLY |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the vacuum switching valve assembly from the air cleaner hose.
![]() |
Disconnect the mass air flow meter connector and 2 wire harness clamps from the air cleaner cap sub-assembly.
![]() |
Separate the fuel vapor feed hose from the air cleaner hose.
![]() |
Disconnect the ventilation hose from the cylinder head cover.
![]() |
Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.
![]() |
Release the 2 clamps and remove the air cleaner cap sub-assembly.
| 5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| 6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the wire harness clamp.
Remove the 2 bolts and air cleaner case sub-assembly.
| 7. REMOVE AIR BAG SENSOR ASSEMBLY |
| 8. REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY |
| 9. DISCONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY |
Turn back the floor carpet.
![]() |
Remove the bolt and nut, and disconnect the No. 1 parking brake cable assembly.
| 10. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY |
Move the shift lever to N.
![]() |
Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.
Disengage the 2 claws and disconnect the transmission control cable assembly from the lower shift lever assembly.
![]() |
Disconnect the wire harness clamp.
![]() |
Remove the nut and clip, and disconnect the transmission control cable assembly.
![]() |
Turn back the dash panel insulator.
Remove the 2 bolts and pull out the transmission control cable assembly from the body.